Cause of crushed OP state after install another code in CLion

HyunyongCho

I have tried to develop control application in documentation right after I made EPOS op state with MCX-A4.
I was successfully finished checking "test" in oploop as provided instruction in documentation.
then i found EPOS4 op state doesn't keep going any more.
So i made again EPOS4 op state like previous setup such as re-deploy machine app, config file, gui file from mcx store, and re-setting ECAT parts.
I have question at this moment, If i installed another code, existed app was replaced by new another code?
What is the solution if i want to use now app that make EPOS4 op state with specific automatic motion such as simple repeated motion?
Please check about this then inform me.

Thank you.

Best Regards.

Hyunyong Cho

HyunyongCho

As i asked in previous chat, I was wondering the solution with installed app that can make EPOS4 op state.

I assumed that "developing client application chapter" of documentation can be solution. and also i don't need to do any touch in MCX-A4. is that correct ?

if correct, i just need to develop client application on remote PC.

Please check about it, too.

Thank you.
Best Regards.

Hyunyong Cho

Philippe

Hi Hyunyong,

It is a good step to start with a ready-configured app like is described in the Getting Started Documentation (No-Code) and then learn how to interface with this app with a client application (Low-Code).
If you want to develop your own realtime software from scratch, you can try "Developing Control Applications". This is of course the most challenging, but gives you the most freedom.

To explain the development process you can also visit this page: https://motorcortex.io/how-it-works

For both Low-Code (Client apps) and Any-Code (Control apps) we have made a VSCode plugin.